How much space do you need for a home Hyperbaric Oxygen chamber?

The space you need is larger than the chamber itself. Plan for the complete installed system, comfortable access and the clearances specified for your chosen model. There is no single room size that suits every Hyperbaric Oxygen chamber.

A useful first step is to send the team a simple room sketch with measurements and photographs of the route into the room. This helps identify access questions before you settle on a model.

Measure the complete setup

Ask for the installed W, L and H of the exact chamber and size you are considering. Confirm whether a quoted dimension describes the chamber alone or the complete arrangement with supporting equipment.

For example, the Oxydise Lying Chamber 1.5 ATA is supplied with an oxygen concentrator and a compressor. Those components need to be included in the room plan, along with the connections between them.

• Mark the chamber footprint on your sketch.
• Add the position of the supporting equipment.
• Mark the entry point and room needed to get in and out comfortably.
• Show doors, radiators, sockets and furniture that may affect placement.
• Ask the team to confirm ventilation and service-access clearances.

Check the journey from the entrance

A room can be large enough while its access route is unsuitable. Measure the narrowest doorway and note tight corners, corridors, steps, stairs and lifts. Ask about the delivered component sizes as well as the final assembled dimensions.

Photograph awkward turns from both directions. Include any restrictions on parking or unloading and explain if the room is on an upper floor. Let the installation team determine what is feasible rather than assuming the equipment can be taken apart to pass through a gap.

Think about everyday use

Choose a location where the equipment can remain accessible. Consider whether you can enter and leave comfortably, whether another person may need access and whether the setup leaves a clear route through the room.

Ask about the sound of the supporting equipment, power requirements and room conditions for the exact system. A photograph can help with an initial discussion, but it cannot replace confirmation of the installation requirements.

Would a sitting or lying chamber fit better?

Compare both the layout and your preferred position. A sitting chamber and a lying chamber organise the usable space differently. The smaller-looking option is not automatically the easier one to enter or the better choice for your room.

Look at the Sitting Chamber 1.5 ATA alongside the lying model and explain any mobility or comfort requirements before making a decision.

What measurements should you send?

Send the room W, L and H, the narrowest door opening, details of stairs or lifts and photographs of the intended position. State the model and size you are considering. The team can then tell you what further measurements are needed.

Next, read what to confirm about delivery, installation and training.

Talk through your options

Call Edward on 01223 657444 to discuss the equipment and your practical requirements. You can also email the team.